Initial Tv Setup; Setting Up Tv Inputs - Mitsubishi Electric LT-46149 Owner's Manual

14
2. TV Setup

Initial TV Setup

Use the Setup menu for basic TV setup options.
1.
Press MENU to open the Main menu.
2.
to highlight the Setup icon and display the
Press
Setup menu.
Memorizing Channels
For Reception on ANT 1 and ANT 2
Note: If using a CableCARD, the TV will automatically
acquire the complete list of available channels
from the service provider. Perform channel
memorization for ANT 1 CableCARD service only
if you need to reacquire the channel list.
To start channel memorization
1.
Connect the incoming cable to
This is the cable from an antenna or a cable service
without a cable box.
2.
With the Setup menu displayed, press
light the Scan icon.
Start channel memorization from the Setup menu.
3.
Press to highlight an input selection based on
your connections:
Input Condition
Ant 1 Air When connected to an indoor or
Ant 2 Air outdoor antenna
Ant 1 Cable When connected to direct cable (no
Ant 2 Cable
cable box)
4.
Press to highlight the on-screen START button.
5.
Press ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
6.
When memorization is complete you can:
• Press MENU once to return to the top row of icons.
• Press MENU again to return to the Main menu.
• Press EXIT to watch TV.
After channels have been memorized:
• To tune to memorized channels, press CH
while watching TV on the ANT 1 or ANT 2 input.
ANT 1 or ANT 2.
to high-
/
• Use the Setup > Edit menu (page 47) for additional
channel options, such as adding or deleting chan-
nels from memory, naming channels, and saving
favorite channels in custom memory banks.
More Setup Options
See chapter 5, "TV Menu Settings," to:
• Set the TV clock (page 48)
• Set the TV Timer (page 49) to have the TV power on
at a preset time.
• Select an Energy Mode to manage power use while
the TV is off (page 49).

Setting Up TV Inputs

When You First Connect a Device
The TV's Easy Connect™ Auto Input Sensing feature
detects most connections automatically.
Note: For connection and setup of a personal com-
puter, see the information on page 18.
Auto Input Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connection and automatically switch
to the input
b. Prompt you to identify the device type (if not
recognized automatically)
c. Prompt you to perform NetCommand IR setup
for the device, if available
d. Repeat these steps for any additional newly
detected devices
See below for connections which trigger Auto Sensing.
Auto Input Sensing Available
Y/VIDEO (detected as composite video)
Y/VIDEO plus Pb (detected as component video)
S-VIDEO
*
HDMI
USB (USB photo port)
INPUT 4 AUDIO (for an audio-only device; see page 26.)
Auto Output Sensing Available
DIGITAL AUDIO OUTPUT (orange jack)
AVR AUDIO OUTPUT/
SUBWOOFER OUTPUT (red jack)
No Auto Sensing
ANT 1 and ANT 2
If the device is powered off when connected, detec-
*
tion occurs when the device is next powered on.