Tv Setup; Guidelines For Setting Up And Using Your New Widescreen Tv - Mitsubishi Electric LT-46149 Owner's Manual

12
2
TV Set-Up

Guidelines for Setting Up and Using Your New Widescreen TV

Getting Started
1.
Review the important safety, installation, and oper-
ating information at the beginning of this book.
2.
Choose a location for your TV.
• Allow at least four inches of space on all sides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV.
• Avoid locations where light may reflect off the
screen or where the TV is exposed to direct
sunlight.
• Refer also to "Installation Notes," page 5.
3.
Install the batteries in the remote control. See page
30 for more on use of the remote control.
4.
Plug your TV into a power outlet. The green LED on
the front of the TV will start blinking rapidly. After
the green LED stops blinking, press the POWER key
to power on the TV.
5.
When the Welcome screen appears the first time
you power on the TV, select a language for TV
menus. You can later change the language through
the Setup menu.
6.
Connect your audio/video (A/V) devices to the TV
and perform initial setup.
• See the following pages for initial TV setup and
use of the Auto Input Sensing feature.
• See chapter 3, "TV Connections," for connec-
tion diagrams.
• To connect the TV to a personal computer, see
"Using the TV with a Personal Computer," page
18.
• Home-theater control can be set up after detec-
tion of each device or can be postponed until
any convenient time afterward.
- See chapter 6, "NetCommand IR Control,"
to set up IR control of your home theater.
- If you plan to use CEC-compatible devices
with the TV's NetCommand for HDMI
feature, review Appendix E.
7.
Mitsubishi recommends you perform a channel
scan for channels received on ANT 1 and ANT 2.
See "Memorizing Channels," page 14.
8.
You can now start watching TV or you can perform
additional setup and customization through the TV
menus.
Installing the Remote Control
Batteries
1.
Remove the remote control's back cover by
gently pressing in the tab and lifting off the
cover.
2. Load the batteries, making sure the polarities
(+) and (-) are correct. For best results, insert
the negative (-) end first.
3.
Snap the cover back in place.
1
2
Turning the TV On or Off
To turn the TV on or off, point the remote control
at the front of the TV and press the POWER button.
Alternatively, press the POWER button on the TV's
control panel.
When You First Power On the TV
Choosing a Language for Menus
1. Power on the TV for the first time.
2. Press to select either English or Spanish
for all menus. You can later change the lan-
guage selection through the Setup > Lan-
guage menu. See page 46.
The remote
control requires
two AA alkaline
batteries.