Caple Wi6224 Instruction Manual

Caple Wi6224 Instruction Manual

Slot-in wine cabinet
Hide thumbs Also See for Wi6224:

Advertisement

Quick Links

Instruction manual for slot-in wine cabinet
Model code: Wi6224
Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Wi6224 and is the answer not in the manual?

Questions and answers

Summary of Contents for Caple Wi6224

  • Page 1 Instruction manual for slot-in wine cabinet Model code: Wi6224 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk...
  • Page 2: Important Safety Instructions

    The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand. If the supply cord is damaged, it must be replaced by a Caple service agent or a similarly qualified person in order to avoid a hazard.
  • Page 3: Installation Instructions

    Plug the Wine cabinet into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorised Caple service centre. Attention •...
  • Page 4 OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL Please use the cabinet within ambient temperatures of under 5-32 , if the ambient °C temperature is higher than or lower than this, it will cause temperature fluctuation in the cabinet, which may prevent it reaching 5-18 °C Controls •...
  • Page 5 Note • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the wine cabinet will not start. • When you use the Wine cabinet for the first time or restart the appliance after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout.
  • Page 6: Care And Maintenance

    Installation diagram CARE AND MAINTENANCE Cleaning Your Wine cabinet • Turn off the power, unplug the appliance and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.
  • Page 7: Troubleshooting Guide

    PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE Wine cabinet does not operate.
  • Page 8: Humidity Maintenance System

    DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates.

Table of Contents