Table of Contents
Advertisement
2.6 Emergency Eject hole
When the drive can not eject the Disc Tray because of power failure,
pushing the Emergency Eject hole of the Front Panel by the thin pole make
drive be able to eject the Disc Tray.
Caution: This function is only for emergency case. Do not use
this function in usual case to prevent from mechanical
damage.
2.7 Power Connector
Used to connect to the host computer' s power supply (DC 5V/12V)
Caution: Be careful not to reverse the poser connector when
attaching it. A reversed connection may cause damage to the
equipment (not covered by the warranty).
2.8 E-IDE Connector
Use a 40 pin double-end flat E-IDE cable to connect to the E-IDE interface.
Caution: Connecting or disconnecting connectors while power
is on may result in a short circuit, causing damage to the
equipment. When connecting or disconnecting connectors,
make sure to turn off the power beforehand.
2.9 Audio Output Connector
Used to connect to the sound card. (Analog signal.)
10
Advertisement
Table of Contents
