Table of Contents
Advertisement
2.10 Digital Audio Output (Not used)
Used to connect to the sound card. (Digital signal.) It is not used with this
drive.
2.11 Device Configuration Jumper
Used when selecting the Device Configuration of E-IDE. Don't use jumpers
to change anything besides the Device Configuration, but keep the drive as
initially set ("Master" position). Configuration changes become valid after
power is turned off, then on again.
Caution: Installing jumper pins besides the ones for Device
Configuration settings may be the cause of damage or
abnormal drive operation.
Fig. 4 Device Configuration Jumper
The Device Configuration Jumper will be set to Master as factory setting.
3. Installation
The Connectors are located as shown below. The function of each parts
are also described below.
11
Advertisement
Table of Contents
