American Standard 2748 Specification Sheet page 2

41-5/8"
(1057mm)
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP
OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIALS BY OTHERS.
●
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING
SYSTEM PIPING AND DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.
OPTIONAL TILING BEAD KIT No. 751755-200 AVAILABLE.
■
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BATH FOR ADDITIONAL INFORMATION.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 / CSA Certified.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.
© 2008 AS America Inc.
CONTROL
PANEL
29-3/4"
(755mm)
14-1/2"
(368mm)
FLOOR CUTOUT
9" X 18"
(229 X 458mm)
AIR
BLOWER
PROVIDE ACCESS TO BLOWER FOR
SERVICE ON ALL INSTALLATIONS
AIR
BLOWER
C/L OF
2"
OVERFLOW
(51mm)
5-3/4"
(146mm)
1-1/2" N.P.T. THREADS
3-1/8"
3/4"
1-1/2" O.D. TAILPIECE
(79mm)
(19mm)
GENERAL SPECIFICATIONS FOR 2748
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT )
3
ELECTRICAL SPECIFICATIONS
BLOWER
TOWN SQUARE
59-1/2"
(1511mm)
INTEGRAL
FITTING DECK
2-1/2" X 14"
(64 X 356mm)
10-1/4"
(260mm)
7-3/4" TYPICAL
(197mm)
OUTLINE OF SKID
RESISTANT SURFACE
LEVELING STRINGER
(NOT FOR SUPPORT)
ROUGH
FLOOR
INTEGRAL FEET WITH
ATTACHED BASEBOARD
AIR MASSAGE SYSTEM
59-1/2 x 41-5/8 x 23 In. (1511 x 1057 x 584mm)
110 Lbs. (50 Kg.)
611 Lbs. (278 Kg.)
60 Gal. (227 L)
34 x 24 In. (864 x 610mm)
52 x 31 In. (1321 x 1321mm)
12-1/2 In. (318mm)
40 Lbs./Sq.Ft. (194 Kgs./Sq.m)
1.0 HP, 10 AMPS ,120V.
H28
PREMIUM AIR BATH
3"
(76mm)
5-1/4"
(133mm)
C/L OF
DRAIN
OUTLET
EDGE OF
FLOOR
CUTOUT
OUTLINE OF CUTOUT
58" X 40-1/8"
(1473 X 1019mm)
20 AIR JETS
3/4"
(19mm)
23"
(584mm)
21"
(533mm)
27.8
45.4
5' x 42"
®
HIGH GLOSS
Rev. 2/08