Download  Print this page

Installation; Positioning; Rear Spacers; Electrical Connection - Electrolux EU 2421 C Installation And Instruction Manual

Electrolux freezer
Hide thumbs

Advertisement

INSTALLATION

If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance. This will prevent it from becoming a
death-trap for a child.

Positioning

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.
Best performance is obtained with ambient tempera-
ture between +18 C and +43 C (class T); +18 C and
+38 C (class ST); +16 C and +32 C (class N); +10 C
and +32 C (class SN).
The class of your appliance is shown on its rating
plate.
Ensure that air can circulate freely around the back of
the cabinet.
To ensure best performance, if the appliance is posi-
tioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall
unit must be at least 5 mm (Fig. 1-A).
Ideally, however, the appliance should not be posi-
tioned below overhanging wall units (Fig. 1-B).
Accurate levelling is ensured by one or more adjusta-
ble feet at the base of the cabinet.
A
B
NP007
4
Fig. 1

Rear spacers

In the bag with the documentation, there are two
spacers which must be fitted as shown in the fig-
ure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
PR153

Electrical connection

Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.

Cleaning the interior

Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
Fig. 2

Advertisement

loading