To Change The Light Bulb; Something Not Working - Electrolux EU8216C Instruction Booklet

To Change the Light Bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Press the spring together and push the grille
downward at the same time.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.

Something Not Working

Before contacting your local Service Force Center check the following point:
Problem
It is too warm inside the freezer.
It is too cold inside the freezer.
Too much frost and ice are produced.
Too much frost and ice are produced.
The compressor operates continuously.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
Possible cause / Remedy
Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
Set a higher temperature.
Action Freeze could have been switched on.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a higher temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a higher temperature.
Set a higher temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The power plug is not properly connected.
The fuse has blown.
The cabinet is not switched on.
Power does not reach the cabinet. (Try connecting another
electrical device to the power outlet.)
9
GB
Electrolux 818 14 99- -00/8