Table of Contents
Advertisement
• For extractor versions (13A), connect the other end of the exhaust
pipe to the flue.
For filter versions (13F), fit deflector F to the support and secure it to
the bracket supplied using 4 screws, then connect the exhaust pipe
to the connection ring located on the deflector.
• Fit the nuts with fixing hooks (14) supplied inside the top and bottom
sections of the flues at the rectangular slots. A total of 10 nuts must
be fitted.
• Join the two top sections of the flue to cover the support (15) so that
one of the slots on the sections is situated on the same side of the
control panel and the other on the opposite side. Screw the two
sections together with 4 screws (2 each side- see the plan diagram
for joining the two sections).
• Fix the top flue assembly to the support, near the ceiling, with two
screws (16 - one each side).
19
Advertisement
Table of Contents
