Connecting A Composite Video Source Device - InFocus X17 Reference Manual

Connecting a composite Video source device

Examine your Video source device to determine if it has a set of unused composite
Video output sockets available:
• If so, you can continue with this procedure.
• If not, you will need to reassess which method you can use to connect to the
device.
To connect the projector to a composite Video source device:
1. Take a Video cable and connect one end to the composite Video output
socket of the Video source device.
2. Connect the other end of the Video cable to the VIDEO socket on the
projector.
3. If you wish to make use of the projector (mixed mono) speaker in your
presentations, take a suitable audio cable and connect one end of the cable to
the audio output socket of the device, and the other end to the AUDIO socket
of the projector.
Once connected, the audio can be controlled by the projector On-Screen
Display (OSD) menus. See
The final connection path should be like that shown in the following diagram:
AV device
• The projector is only capable of playing mixed mono audio, even if a stereo audio input is
connected. See
• If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and
operating correctly. Also check that the signal cables have been connected correctly.
• You need only connect to this device using a composite Video connection if Component
Video and S-Video inputs are unavailable for use. See
on page 15
18 Connection
"Connecting audio" on page 15
for details.
"Adjusting the sound" on page 34
Audio cable
Video cable
for details.
"Connecting Video source devices"
for details.