UHF-CB
SCANNING with PRIORITY CHANNEL
The scan function scans channels that are in the scan memory and stops at an active
channel. Whichever channel you have selected when SCAN begins becomes the priority
channel. SCAN will check the priority channel every 1.5 seconds.
To initiate scanning:
1. Press
momentarily to begin scanning. The Scan icon flashes on the
SCAN
display.
2. Press PTT or any function key to cancel SCAN Mode.
If SCAN is cancelled while stopped on a busy channel that channel will be the exit
channel.
If SCAN is cancelled while scanning then the unit will exit to the priority channel.
SCANNING - SCAN MEMORY
You can only scan channels which are currently in the scan memory. By default all
channels are active in the scan memory.
To add or remove channels from the scan memory:
1. Select a channel using scroll
2. Press and hold
.
SCAN
'MEMORY' is displayed to indicate the channel is in the scan memory.
REPLY DELAY
While scanning, the GPS 205 stops at a busy channel and receives a transmission.
When the received signal is over, the unit will wait for 3 seconds for the return of the
signal, otherwise, the radio resumes scanning.
or
.
10