Pppoe (Dsl) - D-Link DIR-300 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
PPPoE: Select Dynamic (most common) or Static. Select Static
if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses.
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password
in the next box.
Service Name:
Enter the ISP Service Name (optional).
IP Address:
Enter the IP address (Static PPPoE only).
DNS Addresses:
Enter the Primary and Secondary DNS Server Addresses
(Static PPPoE only).
Maximum Idle
Enter a maximum idle time during which the Internet
Time:
connection is maintained during inactivity. To
disable this feature, enable Auto-reconnect.
MTU:
Maximum Transmission Unit - You may need to change
the MTU for optimal performance with your specific ISP.
1492 is the default MTU.
Connection Mode
Select either Always-on, Manual, or Connect-on
Select:
demand.
D-Link DIR-300 User Manual
Internet Setup

PPPoE (DSL)

0