Inuse Line Setup (Base Only) - Uniden DSS7960+1 Owner's Manual

Inuse.Line.Setup.(Base.only)
The Inuse Line Setup feature is only used in instances where you have multiple phones where users may pick up an
extension while someone else is on the phone. Only in very rare instances where your phone system is not detecting
that an extension phone is picked up will you ever need to change this feature. In most all situations, this feature will
never need to be used or modified from the factory default setting of TYPE-A. There are three settings for this fea-
ture: TYPE-A, TYPE-B, or OFF.
You should only change this option when instructed to by customer service and when you are experiencing one of
the following issues:
Issue
When using an extension phone,
"Line in Use" will not appear in the
original handset display.
You place a caller on hold. You pick
up an extension handset and finish
your conversation. You hang up the
call from your extension handset,
but the original station where you
placed the caller on hold does not
release the line and therefore, thinks
you still have a party on hold.
Note: Do not set your Inuse Line Setup to OFF unless instructed to by a Uniden Customer Service Representative. If
you set the Inuse Line Setup to OFF, your phone cannot detect the status of an extension phone while in use and will
not operate correctly.
Problem
Your phone should detect when an-
other extension phone is used.
Your phone system is not detecting
that the line was picked up and re-
leased.
56
Resolution
Set the Inuse Line Setup to "TYPE-
B" or visit Uniden's customer sup-
port page at www.uniden.com.au
(Australian model) or www.uniden.
co.nz (New Zealand model).
Visit Uniden's customer support
page at www.uniden.com.au (Aus-
tralian model) or www.uniden.co.nz
(New Zealand model).