Denon AVR-1610 Owner's Manual page 24

ENGLISH
Step 1 : Connect the included Setup Microphone
NOTE
• Do not disconnect the setup microphone until the Audyssey Auto
Setup procedure is completed.
• When using headphones, unplug the headphones before starting
the Audyssey Auto Setup procedure.
1
Check the speaker connections.
"
( v page 11 Connecting the Speakers
2
Turn on the power of the TV and subwoofer.
Set the TV's input to the AVR-1610.
3
Turn on the AVR-1610's power.
"
( v page 16 Turning the Power On
4
Connect the included calibrated setup microphone to
the SETUP MIC jack on the main unit.
The Audyssey Auto Setup screen appears automatically.
Sound
receptor
5
Mount the setup microphone on a tripod or stand and
install it at the main listening position.
When installing the setup microphone, adjust its height so that
the section where the sound is received is at the height of the
ears during listening.
Setup
microphone
20
NOTE
• Do not hold the microphone in your hand during measurements.
• Avoid placing the microphone close to a seat back or wall as sound
refl ections may give inaccurate results.
When using a subwoofer on which the volume can
be adjusted and the crossover frequency can be set
"
)
When using a subwoofer, make the following settings before starting
the Audyssey Auto Setup procedure:
n
When using a subwoofer with a direct mode
Set the direct mode to "On" and disable the volume adjustment
and crossover frequency setting.
"
)
n When using a subwoofer without a direct mode
Make the following settings:
• Volume
• Crossover frequency
• Low pass fi lter
• Standby mode
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
If adjustment to the environment is necessary, set the following
items before proceeding.
Setting the speakers for playing the front channel
(Front Sp.)
The front speaker to be measured can be selected ahead of time
here.
1
2
:"12 o'clock position"
:"Maximum/Highest Frequency"
:"Off"
:"Off"
n
Step 2 : Audyssey Auto Setup
Preparations
around items indicate the settings made upon purchase.
Press ui to select "Front Sp.".
Use op to select the speakers.
3-1.Audyssey Auto Setup
Please place microphone
at ear height at
main listening position.
Front Sp.:
Pre Assign:
Normal
Start
Cancel
[ENT]:Select [RTN]:Back
A
: The sound is output from front speakers A when measuring
the front speakers.
B
: The sound is output from front speakers B when measuring
the front speakers.
A + B
: The sound is output simultaneously from front speakers A
and B when measuring the front speakers.
To cancel Audyssey Auto Setup
Use ui to select "Cancel", then use o p
MultEQ
A
to select "Yes".