HUSKY LINERS 2107 Care And Use Instructions

THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this "relaxing" may take longer; moving the liner inside will speed up the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409 ® or Glass Plus ® work well.
Use of Armor All ® , Son-of-a-Gun ® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVY
EQUINOX/PONTIAC TORRENT CARGO LINER
TO ACCESS THE FACTORY CARGO TIE-DOWN HOOKS
WITH YOUR LINER IN PLACE, MAKE A HORIZONTAL SLIT
ACROSS THE CENTER OF THE TWO (2) RAISED AREAS
SHOWN HERE DARKENED/CIRCLED. THEN, PUSH/PULL
THE HOOKS UP THROUGH THE LINER.
IF YOUR VEHICLE IS EQUIPPED WITH THE OPTIONAL "SUN AND SOUND" STEREO SYSTEM, IT HAS
A SUBWOOFER MOUNTED IN THE REAR RIGHT HAND CORNER OF THE CARGO AREA. THIS
FEATURE WILL ALSO KEEP YOUR CARGO LINER (AS IT IS BOXED) FROM FITTING CORRECTLY.
HOWEVER, YOUR LINER CAN EASILY BE TRIMMED TO ACCOMMODATE THIS FEATURE. TO TRIM,
CUT ALONG THE OUTER EDGE OF THE MOLDED STEP AND ALONG THE EDGE OF THE TREAD ON
THE RAISED PORTION OF THE LINER. THIS WILL LEAVE A _" LIP ALONG THE TRIMMED EDGE (SEE
BACK OF PAGE FOR TRIMMING PHOTOS).
CARE AND USE INSTRUCTIONS
2107 Front_Back.doc
01/20/2006