Preparing The Fixing Points - Miele T 4819 Ci Operating Instructions Manual

For right hand hinging only:
– front panel shown decor side face
down, upper edge at the bottom:
if width (b) increases, measurement a
must also be increased
b = 592 mm N a = 21.5 mm
b = 593 mm N a = 22.0 mm
b = 594 mm N a = 22.5 mm
b = 595 mm N a = 23.0 mm
b = 596 mm N a = 23.5 mm
H = height of adjacent furniture unit
doors.
Drill the two hinge holes (C 35
mm/15.5 mm deep) in the back of
the front panel.
Next, drill the four smaller holes
(C 7 mm/10 mm deep) in the back of
the front panel.
Shorten the front panel from the
bottom to height H.

Preparing the fixing points

Hold the pre-drilled front panel in the
correct position in front of the
machine door.
Mark the fixing points on the back of
the front panel through the holes in
the machine door plate (see arrows
in the illustration).
Remove the front panel.
Now drill holes (C 2.5 mm/10 mm
deep) in the back of the front panel.
Installation
47