Table of Contents
Advertisement
Maintenance
1. Bodywork
Clean the outside of the machine with warm water and a
neutral, non-abrasive household detergent. Rinse with
clean water and dry with a soft cloth.
Important: do not use methylated spirits, solvents or
similar products to clean the bodywork.
2. Detergent dispenser drawer
After a while, detergents and fabric softeners leave
deposits in the drawer.
Clean the drawer from time to time by rinsing it under a
running tap. To remove the drawer from the machine,
press the button in the rear left-hand corner.
To facilitate cleaning, the top part of the additive
compartments can be removed.
R0072
Detergent can also accumulate inside the drawer recess:
clean it with an old toothbrush. Refit the drawer after
cleaning.
C0073
3. Cleaning of the drainage area
The drainage area must be cleaned if the pump has
been blocked with objects such as buttons, safety pins,
coins, etc. , or if lint has built up because clothes that
generate lint have been washed at high temperatures.
• Pull out the plug from the power socket.
• If necessary, wait until the water has cooled down.
• Open the drainage area door.
• Place a bowl to collect the water.
• Release the emergency emptying hose, place it in the
bowl and remove its cap, when the bowl is full put the
cap back on the emergency emptying hose.
• Empty the bowl. Repeat the procedure until you have
completely emptied the washing machine.
P1114
• To continue, unscrew the lid of the diaphragm by
turning it counter clockwise and pull it out.
• Remove the objects such as buttons, coins and the lint
that has been accumulated in the area of the pump
impeller by rotating it.
• Screw the lid of the diaphragm clockwise, be sure is
completely tighten.
• Replace the emergency emptying hose in its initial
position and close the drainage area door.
P1116
11
P1115
P1117
Advertisement
Table of Contents
