Husqvarna GTH2550XP Owner's Manual page 24

Table of Contents

Advertisement

SERVICE AND ADJUSTMENTS
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractor. If
damage has occurred to affect the front wheel camber,
contact your nearest authorized service center/department.
FRONT OF TRACTOR
JAM NUTS
ADJUSTMENT SLEEVE
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 29)
Block up axle securely.
Remove axle cover, retaining ring and washers to allow
wheel removal.
Repair tire and reassemble.
Replace washers and snap retaining ring securely in axle
groove.
Replace axle cover.
REAR WHEEL -
Block rear axle securely.
Remove five (5) hub bolts to allow wheel removal.
Repair tire and reassemble. Replace and tighten hub
bolts securely.
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
WASHERS
RETAINING
RING
AXLE COVER
B
A
FIG. 27
ADJUSTMENT SLEEVE
TIE ROD
FIG. 28
FIG. 29
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 30)
CAUTION: Lead-acid batteries generate
explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection when
around batteries.
If your battery is too weak to start the engine, it should be
recharged. (See "BATTERY" in the CUSTOMER RESPON-
SIBILITIES section of this manual).
If "jumper cables" are used for emergency starting, follow
this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
Connect each end of the RED cable to the POSITIVE (+)
terminal of each battery, taking care not to short against
chassis.
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal of fully charged battery.
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
BLACK cable first from chassis and then from the fully
charged battery.
RED cable last from both batteries.
"POSITIVE" (+)
24
"NEGATIVE" (-)
L.H. PANEL
BOLT
FIG. 30

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gth 2250

Table of Contents