Cold Water Cleaning - DeLonghi PENTAVAP Instruction Booklet

16/28 GB 3-01-2003 10:36
EXTRACTION CLEANING TECHNIQUES
Extraction cleaning with cold or hot water, or
steam, is performed as follows:
- spray the detergent solution or the steam jet
onto the surface to be treated by pressing the
spray trigger (1) while simultaneously
vacuuming from front to back (fig. D).
go over the same area several times,
vacuuming only.The treated surface will then be
free of dirt and almost completely dry.
D
IMPORTANT NOTICE: set suction at
maximum power for the electronic version.
COLD-WATER CLEANING
(WITH SHAMPOO)
Cold-water cleaning is particularly
recommended for delicate unwaxed hard floors
like fired-clay tiles, parquet floors and all textile
flooring (rugs, carpeting).
Fit your PENTAVAP with the tool required for
the desired type of cleaning.
Rotate the selector of the PENTAVAP solution
injection system to the shampoo position to
obtain spray action for the water and shampoo
solution (fig. E).
Pagina 24
E
Plug in your PENTAVAP (green light (18) on)
and depress the suction (19) and cold-water
cleaning (21) buttons on (red light (24) on)
(fig. F).
At this point your PENTAVAP is ready for
extraction cleaning.
To switch the machine off, depress the cleaning-
lock (20) and suction (19) buttons.
F
NOTICE: noise level. After setting up your
machine, you may notice an increase of the
noise level for a few seconds. This is not due to
a defect in the machine but to the water starting
to circulate for the first time. Should the noise
continue for more than 15 seconds, check that
the suction inlet tube is correctly connected to
the motor unit. When the water in the tank runs
out, the noise level will increase once again. At
this point, switch off the machine and proceed to
refill the tank as described in the instruction
booklet.
IMPORTANT: the pump noise level acts as an
acoustic warning that the water in the tank has
run out.
24