Table of Contents
Advertisement
Rear Panel
1. Cooling fan
• The fan always turns when the power is on.
Provide a minimum of 6 inches (15 cm) of clear
space on all sides of the fan when you install the
product.
2. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on the
rear of the system.
1. To achieve the correct sound quality, insert the
speaker connector cables identified below into the
correct speaker terminals on the back of the sys-
tem.
• L eft speaker (marked L).
• R ight speaker (marked R).
3. ONLY FOR SERVICE
• T his jack is for service only. Please do not use.
4. AUX IN 2 Terminals
1. Use an Audio Cable (not supplied) to connect AUX IN
2 on the product to Audio Out on an external analog
component.
• B e sure to match connector colors.
• I f the external analog component has only one
Audio Out jack, connect to either the left or right
terminal.
• Press the TUNER/AUX button to select the AUX 2
input.
1
2
3
4
5
6
• When the unit is in AUX mode, if none of the
buttons on the front panel are pushed for more
than 8 hours, the power will automatically turn off.
5. FM Antenna Connector Terminal
1. Connect the FM antenna (supplied) to the FM Antenna
jack.
2. Slowly move the antenna wire until you find a location
where reception is good, then fasten it to a wall or
other rigid surface.
3. If reception is poor, you may need to install an outdoor
antenna. To do so, connect an outdoor FM antenna to
FM antenna jack on the rear of the system using a
75Ω coaxial cable (not supplied).
6. LED Terminals for the Front Speakers
To enjoy the special light effect of the speakers, connect
the LED cables of the Front Speakers to the LED
terminals of the system.
7
6
English
English
Advertisement
Table of Contents
