Table of Contents
Advertisement
VersaBALL_Pro_User's_Guide_v1.0.qxd
8/20/2004
10:26 AM
Assembly Instructions
STEP 3
STEP 4
Page 7
BOLT B
Assemble adjustable seat tube to upper ring and
lower base ring. The tube should fit on top of the
upper ring and over the bottom male connection
point. At this point only assemble the tube to the
upper ring using 1 BOLT B, 2 curved washers,
and a nut.
Note: Assemble one bent washer on each side
of the bolt/nut connection point.
Also assemble pull-pin by turning the pull-pin bolt
clockwise.
Note: The pull-pin has a pulling and a locking
feature. To unlock the pull-pin twist the pullpin
counterclockswise.
Using 4 Bolt D's and 4 flat washers assemble
seat post tube to seat.
Note: Make certain to assemble the seat in the
correct direction. Seat post tube holes should be
facing away from the machine. See diagram.
BOLT D
9
Parts List
(A) M8x52 ALLEN BOLT (QTY 3)
(B) M8x45 ALLEN BOLT (QTY 3)
(C) M8x38 ALLEN BOLT (QTY 4)
(D) M8x16 ALLEN BOLT (QTY 11)
CURVED WASHER
QTY 19
FLAT WASHER
QTY 7
LOCK NUT
QTY 10
6
Advertisement
Table of Contents
