Setting The Water Softener - Electrolux ARTHUR MARTIN ASL67050 User Manual

• Remove all packaging from inside the ap-
pliance
• Set the water softener level
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser

Setting the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
Water hardness
°dH
51 - 70 91 - 125
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. set the multitab function. (Re-
fer to 'Multitab function').
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
2
2
2
2
1
1
1
1
Setting electronically
The dishwasher is factory set at level 5.
1. Press the on/off button. The dishwasher
must be in setting mode.
electrolux 7
Use of
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no