Unloading The Dishwasher; Select And Start A Washing Programme - Electrolux ARTHUR MARTIN ASL67050 User Manual

16 electrolux
4. To change the setting, press button B
again, the digital display indicates the
new setting.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multitab function.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless

Select and start a washing programme

Important! Set the options before the start
of a washing programme. When a washing
programme operates, no options can be set.
If it is necessary to set an option, cancel the
washing programme.
Select the washing programme and de-
lay start with the door slightly opened.
The start of the programme or the count-
down of the delay start will occur only
after the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Set the desired washing programme. Re-
fer to 'Washing programmes' for details.
5. Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. Set the washing programme. Press the
delay start button until the flashing num-
ber of hours for the delay start shows in
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
steel will eventually become cooler than
the dishes.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
the digital display. The delay indicator
light comes on.
2. Close the appliance door, the countdown
starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically. Delay
start indicator light goes off.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.