Table of Contents
Advertisement
11 CHANGING THE QUANTITY OF HOT WATER
The appliance is factory preset to automatically deliver 8.5 oz of hot water.
To change this quantity, proceed as follows:
• Attach the water spout (fig. 4).
• Position a container under the spout (fig. 3).
• Press the
button for at least 8 seconds then release. The appliance displays:
and hot water is delivered from the water spout.
• When the hot water in the cup reaches the required level, press the
amount. (You should not run off hot water for more than two minutes at a time).
12 PREPARING LATTE OR CAPPUCCINOS (MILK WITH COFFEE )
• Select the taste of the coffee you want to use to make the cappuccino by pressing the
• Remove the frothed milk lid from the milk container.
• Fill the container with about 3.5 ounces of milk for each cappuccino to be prepared (fig. 19). Never
exceed the MAX level (corresponding to about 25 oz) marked on the container. You are recommend-
ed to use milk at refrigerator temperature (about 41°F/5° C).
• Make sure the milk intake tube is correctly inserted in the rubber washer (fig. 20), then put the lid on the
milk container.
• Remove the hot water spout (fig. 21) and attach the milk container to the nozzle making sure the arrow on the
container lid is lined up with the arrow on the control panel of the appliance (fig. 22).
• Position the milk spout as shown in fig. 23 and then place a sufficiently large cup under the coffee and
milk spout.
• If you want to make caffelatte (hot milk + coffee), put the froth regulator on CAFFELATTE.
• If you want to make cappuccino (frothed milk + coffee) using whole milk, put the froth regulator on CAP-
PUCCINO.
• If you want to make cappuccino (frothed milk + coffee) using non-fat milk, put the froth regulator on CAP-
PUCCINO NON FAT.
NOTE: you can put the milk froth regulator in-between the two positions to personalize the volume of the froth.
• Press the
button (fig. 24). The appliance displays:
and after a few seconds, the milk is delivered from the milk spout into the cup below. (Delivery stops auto-
matically).
• The appliance then grinds the beans, delivers the coffee and displays the "ready" message again.
• The cappuccino is ready. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.
NOTE 1: While preparing the cappuccino, milk or coffee delivery can be interrupted by pressing button
NOTE 2: If you run out of milk while delivering the milk, remove the container and refill it. Then put it back
in place and press the
NOTE 3: To ensure the milk frother is absolutely clean and hygienic, after making cappuccinos, clean the
channels inside the milk container lid:
• Place a cup under the milk spout;
• Press the CLEAN button on the frothed milk container lid and hold down for at least 8 seconds. The appli-
ance displays:
14
HOT WATER PROGRAM QUANTITY
cappuccino or latte
button to request a cappuccino again.
CLEANING
button to memorize the new
button.
.
Hide quick links:
Advertisement
Table of Contents
