Table of Contents
Advertisement
• Drain only
- Press the RESET button
cause the light "DRAIN" to light up, then press the
START/PAUSE button.
Important! If you accidentally press the RESET
button more than once, the display will show
three blinking dashes. To drain the water, select
any washing programme by means of the
FABRIC button, then press RESET three times
in order to select the DRAIN position (only the
light DRAIN will remain lit).
6 OPTIONS button
Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool and HAND WASH
programme).
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
drained.
• BIO: this function can be selected for cotton and
synthetics with a washing temperature of 40° or
more degrees.
The machine will maintain a temperature of 40° for
about 10 minutes to enable the enzymes contained
in the detergent to eliminate the dirt.
To be used for laundry with "stubborn" stains.
Note: PREWASH and BIO can be selected together.
Press the button until both lights light up.
7 QUICK WASH button
This button allows you to select the QUICK WASH
function, for laundry that is only slightly soiled (not
for wool and HAND WASH programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
once, so as to
11
8 Display
The following pieces of information are shown on the
display:
• Three blinking dashes, when a programme is
cancelled by means of the RESET button.
The three blinking dashes will also appear when you
press the ON/OFF button to switch the machine on,
if the previously selected cycle has been erased.
• Duration of washing programme in hours
and minutes, after you have selected a
programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
• The washing machine has stopped with water in
the tub, at the end of a programme with the
RINSE HOLD option
static zero.
• The washing machine has completed the
programme: this is indicated by a blinking zero.
At the same time, the door locked light goes out.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
RESET button.
: this is indicated by a
Advertisement
Table of Contents
