Electrical Connection - Electrolux EWX14550W User Manual

C
b) Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth 12.5-14 mm
depending on the depth of door furniture) on
the inner side of the door. The distance be-
tween the holes hobs fixing centres must be
416 mm.
The distance (B) from upper edge of the door
to the centre of the hole depends on the ad-
jacent furniture's dimensions.
The required dimensions are given in the pic-
ture C.
The hinges will be fixed to the door by means
of screws for wood (2-Fig. B) supplied with
the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means
of the M 5x15 screws (3-Fig. B). The hinges
can be adjusted to compensate for possible
uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door
and tighten the screw again.
d) Counter-magnet (6)
The appliance is prearranged for a magnetic
closure of the door.
To enable a correct operation of this device,
it is necessary to screw the counter-magnet

ELECTRICAL CONNECTION

Information on the electrical connection is
given on the rating plate on the inner edge of
the appliance door.
(6) (steel disk + rubber ring) into the inner side
of the door. Its position must correspond to
the magnet (4) on the appliance (see picture
D).
D
6
If the door has to be opened from left to right,
invert the position of the plates (7), the mag-
net (4) and the plate (5) (Fig. B and E). Mount
the counter-magnet (6) and the hinges (1) as
previously described.
E
4
5
Check that your domestic electrical installa-
tion can take the maximum load required, al-
so taking into account any other appliances
in use.
electrolux 29
4
6
1
7
3
2