Electrolux EDC67550W User Manual page 11

Clean the door seal
Wipe the door seal with a damp cloth imme-
diately after the drying cycle has finished.
Emptying the water reservoir
Empty the water reservoir after every drying
cycle.
If the water reservoir is full, an active pro-
gramme will break off automatically and the
empty container
light up. In order to continue the programme,
the water reservoir must first be emptied.
Warning! The condensed water is not
suitable for drinking or for preparing
foodstuffs.
1. Take out water reservoir completely.
2. Pour condensed water out into a basin or
similar receptacle.
icon on the display will
3. Refit water reservoir.
If the programme has been interrupted as
a result of the water reservoir being full:
Press the START/PAUSE button to con-
tinue the drying cycle.
The water reservoir has a volume of ap-
prox. 4 litres. This is sufficient for around
7 kg of laundry which has previously
been spun at 1000 revolutions/ minute.
The condensate can be used as distilled
water, e.g. for steam ironing. However
first filter the condensate (e.g. with a cof-
fee filter) to remove any residue and
small pieces of fluff.
Cleaning heat exchanger
If the HEAT EXCHANGER is displayed,
the heat exchanger needs to be cleaned.
Caution! Operating when the heat
exchanger is blocked with fluff can
damage the dryer. This also increases
energy consumption.
1. Open door.
2. Open door in plinth. To do this, press the
release button on the bottom of the door
aperture and open the door in the plinth
to the left.
electrolux 11