Husqvarna Regina Gastronome QSG1000X Instruction Manual page 30

It is possible to connect the gas in the following ways:
•
•
•
The unit must be coated in heat-resistant material (minimum 90°C). If the appliance is installed
close to other units, the minimum space suggested in the following diagram must be left.
30
Instructions for the installer
using iron or copper rigid pipe;
using uninterrupted stainless steel flexible pipe with a mechanical fitting conforming to
standards regulations in force (maximum length of extended pipe 2000 mm). The pipe should
be connected straight to the elbow of the ramp;
by inserting a flexible rubber pipe conforming to standards regulations in force. This pipe
should be coupled straight to the rubber-holder P corresponding to the gas used, and locked
with a clamp F conforming to standards regulations in force. In the latter case, check the expiry
date printed on the pipe and replace it before that date.
LPG
Using flexible rubber pipes with a max. length of 1500 mm:
• do not allow the pipes to be constricted or crushed;
• pipes must not be subject to tractive force or torsional stress;
• do not allow the pipes to come into contact with cutting or sharp edges, etc...
• do not allow the pipes to come into contact with parts that can reach temperatures of 70°C
above room temperature;
• make sure the entire length of the pipes can be inspected.
NATURAL GAS