Gas Regulations - Husqvarna Regina Gastronome QSG1000X Instruction Manual

Instructions for the installer

12.6 Gas regulations

If the cooking appliance is set up for a different type of gas than that available, its injectors must
be replaced, the minimum flow regulated and the rubber-holder changed. In order to replace the
injectors in the cooking hob, it is necessary to carry out the following operations:
•
remove the pan supports;
• remove the burners and burner caps (Fig. A);
• take out the injector (Fig. B) and replace it with one
suitable for the new type of gas (see "G
" on page 32);
INJECTORS TABLE
•
replace the gas label (on the rear of the appliance) with
the new one provided with the injectors kit;
• refit all parts by following the disassembly instructions in
reverse order and taking care to position the burner cap
correctly on the burner.
12.6.1 Minimum flow of valved cooking hob taps
•
Switch on the burner and turn the control knob
towards the minimum flow position ;
•
remove the knob;
•
using a screwdriver, adjust the internal screw Z
until the correct low flame is obtained;
•
refit the knob.
12.6.2 Minimum flow of non-valved cooking hob taps
•
Switch on the burner and turn the control knob
towards the minimum flow position ;
•
remove the knob;
•
insert a small screwdriver into the rod of the tap
and adjust the internal screw Z until the correct
low flame is obtained;
•
refit the knob.
•
Unscrew the adjustment screw Z to increase the flow, or tighten it to reduce the flow.
•
The adjustment is correct when the low flame measures approximately 3 or 4 mm.
•
For butane/propane, the adjustment screw should be tightened all the way.
•
When changing quickly from maximum to minimum flow and vice versa make sure that the
flame does not go out.
ENERAL
31