Table of Contents
Advertisement
12. Installation
12.1 General warnings
The following operations must be carried out by a qualified installing technician. The
installing technician is responsible for correctly installing the appliance according to
current safety standards. Before using the appliance, remove the protective plastic on the control
panel, stainless steel parts, etc...
The manufacturer declines any responsibility for damage incurred by persons, animals or
objects that is caused by not following the above guidelines (chapter "1. Warnings for
safety and use").
The technical data is indicated on the plate located on the back of the appliance. The adjustment
conditions are shown on a label applied to the packing and the appliance.
Do not use the oven door handle for handling the appliance, or for removing the appliance
from the packing.
12.2 Electric connection
Make sure that the voltage and the current capacity of the mains corresponds to the specifications
shown on the rating plate located on the back of the appliance.
The rating plate must never be removed.
The plug at the end of the power supply cable and the wall socket must be the same type and must
comply with current electric standards. Check that the mains is adequately earthed. Once the
appliance has been installed make sure that the plug is accessible to allow the periodical check-up.
Prepare a double pole isolating device on the power supply line of the appliance with a contact
opening distance equal to or more than 3 mm, located in a convenient position near the appliance.
Do not use adapters or extension cables.
26
Instructions for the installer
DIMENSIONS OF THE COOKERS
Hide quick links:
Advertisement
Table of Contents
