Preparation & Assembly - Stanley P2350S Owner's Manual

Assembly Time: 5 minutes
Tools Required: 17mm Adjustable Wrench, and 8mm /
10mm wrench
Surface Preparation

Before starting any cleaning task, it is important to inspect the area for
objects which could create a hazard.

Remove any objects from the work area which could be tripped over, such
as toys or outdoor furniture.

Ensure that all doors and windows are closed tightly.
Step 1

Remove or peel off blue protective film on the front of the pressure washer
and on the wands (if applicable). Also, remove any bubble wrap. Discard
blue protective film and bubble wrap.
Step 2

Attach the 4 feet to the pressure washer frame with a wrench.
Step 3

Attach the 25' high pressure hose to the pump water outlet
Step 4

Attach the variable wand into the spray gun by turning and
threading the wand into the gun until tight.
8 of 18
PREPARATION & ASSEMBLY
Step 5

Step 6

Step 7


®
STANLEY Electric Pressure Washers
Attach High Pressure Hose to Gun as shown in Figure below.
Fasten tightly with 17mm wrench to avoid leakage.
Attach the soap/detergent bracket, bottle, siphon to the side plate
Before connecting garden hose to water inlet, inspect inlet screen. Clean
screen if it contains debris or replace if damaged. Refer to the section "O-
Ring Maintenance" if inlet screen is damaged. DO NOT run pressure
washer if inlet screen is damaged.
IMPORTANT: Before attaching the garden hose to the pressure
washer, run water through garden hose for 30 seconds to clean out
any debris. Ensure the water is OFF..
Rev: Dec2010