Stanley P2350S Owner's Manual page 12

Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for 3-5 minutes without
pressing the trigger on the spray gun, circulating water in the pump can
reach temperatures above 125°F.The system engages to cool the pump
by discharging the warm water onto the ground.
Step 7
Adjusting the spray

Turning the nozzle allows the use of several different spray.
CAUTION:

Jet spray adjustment is very aggressive. Do not adjust while
spraying. We recommend that for most cleaning applications, a 20
degree spray angle should be used to avoid damage to the surface
being sprayed.
12 of 18
A
Select the desired high pressure spray angle by using the high pressure adjustable wand.
To scour surfaces, adjust wand to D or E angle.
For gentle rinse, adjust wand to B or C angle.
To apply chemical, adjust to low pressure as shown in angle A (for instructions on
adjusting the wand to low pressure, see step 1 on page 13.
STANLEY Electric Pressure Washers
OPERATION
B C
WARNING
High pressure spray could cause you to fall if you are too close to the
cleaning surface.

Keep spray nozzle between 8 to 24 inches away from cleaning surface.

Operate this unit on a stable surface.

Be extremely careful if you must use the pressure washer from a ladder,
scaffolding or any other relatively unstable location.

Firmly grasp spray gun with both hands when using high pressure spray to
avoid injury if gun kicks back.
CAUTION
You must attach all hoses before you start the engine.

Starting the engine without all the hoses connected and without the water
turned ON will damage the pump.

Damage to equipment resulting from failure to follow this instruction will
void warranty.
®
D E
Rev: Dec2010