Step 1:
Make sure that the ON/OFF switch is in the "OFF" position.
Step 2:
Turn ON the water supply.
Important:
Never turn the engine on without having the water turned on.
Running the pump with no water can cause pre-mature pump
damage.
Step 3
Push the primer bulb 3 to 5 times before starting a cold engine.
Step 4
Before turning the unit "ON", depress the trigger to bleed any
trapped air out of the pump and hose.
Rev: Dec2010
OPERATION
Step 5
Step 6
CAUTION:
®
STANLEY Electric Pressure Washers
Release trigger and start the pressure washer by turning ON/OFF
switch to ON.
Pull the recoil to start. To start easier, hold the trigger on the gun
to allow the water to flow. If engine does not start after the 4 or
5th pull, contact customer service at 919-550-3259 for assistance.
Jet spray adjustment is very aggressive. Do not adjust while
spraying. We recommend that for most cleaning applications, a 20
degree spray angle should be used to avoid damage to the surface
being sprayed.
11 of 18