Replacing The Battery - Intel Reader User Manual

Hide thumbs Also See for Reader:
Table of Contents

Advertisement

Chapter 2. Getting Started
button at the lower right of the Reader face. On the Guide menu, select Device
Status and press OK. The Device Status screen appears. The second line under
the screen title tells you the amount of charge for your battery.
IMPORTANT: Before leaving the Reader idle for several months, charge
the battery to approximately 50 percent before shutting down the
Reader or disconnecting the battery. Charging the battery more than
50 percent before long-term storage can result in degraded capacity.
Failure to properly charge the battery can result in a loss of charge that
might make it impossible to recharge your battery.

Replacing the Battery

From time to time, it may be necessary to replace the battery. To do so, turn off
the Reader by pressing the Power button for approximately 7 seconds. Press the
Battery Release on the back of the Reader. Slide the battery toward the camera,
and lift it off the Reader. Then install the new battery, following the instructions in
the section titled Inserting the Battery, earlier in this chapter.
Battery Release
22

Advertisement

Table of Contents
loading

Table of Contents