Before First Use - Electrolux ESL 6610 User Manual

is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold the TimeSaver and the
XtraPower touchpads at the same
time until the Multitab indicator comes
on.
The option stays on until you deactivate it.
Press and hold the TimeSaver and the
XtraPower touchpads at the same time
until the Multitab indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the Multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
5.6 Acoustic signals
The acoustic signals operate when the ap-
pliance has a malfunction or when the ad-
justment of the level of the water softener

6. BEFORE FIRST USE

1. Make sure that the set level of the water
softener agrees with the water hard-
ness in your area. If not, adjust the wa-
ter softener. Contact your local water
authority to know the water hardness in
your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
occurs. It is not possible to deactivate
these acoustic signals.
There is also an acoustic signal that oper-
ates when the programme is completed.
By default, this acoustic signal is off but it is
possible to activate it.
How to activate the acoustic signal for
the end of programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold touchpads (4) and (5) at
the same time until the indicators of
touchpads (3), (4) and (5) flash.
3. Press touchpad (5),
• The indicators of touchpads (3) and
(4) go off.
• The indicator of touchpad (5) contin-
ues to flash.
• The display shows the current set-
ting.
Acoustic signal on
Acoustic signal off
4. Press touchpad (5) to change the set-
ting.
5. Deactivate the appliance to confirm the
setting.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
If you use the combi detergent tab-
lets, activate the Multitab option.
ENGLISH 9