Use Of The Freezer Compartment; Temperature Regulation; Storage Of Frozen Food; Excessive Temperature Alarm - Electrolux EUFG29800W User Manual

Use of the freezer compartment

The freezer is provided with the symbol
which means that it is
suitable for freezing fresh food and for
long term storage of frozen and
deep-frozen food.

Temperature regulation

The temperature may be regulated
between -15°C and -24°C.
We suggest setting the internal tem-
perature of approximately -18°C,
which guarantees proper freezing and
conservation of the frozen foods.
Attention!
During the stability period by the first
starting the temperature displayed can
not correspond to the setting tempe-
rature. During this time it is possible
that the temperature displayed is
different than the setting temperature.
Attention!
Difference between the temperature
displayed and temperature setting is
normal. Especially when:
- a new setting has recently been
selected
- the door has been left open for a
long time
- warm food has been placed in the
compartment.
Difference until 5°C inside the
compartment are quite normal.
During normal functioning the indicator
shows the warmest temperature inside
the compartment.

Storage of frozen food

When first starting-up or after a period
out of use, before putting the products
11
in the compartment let the appliance
run at least 12 hours. To obtain the
best performance from this appliance,
you should: if large quantities of food
are to be stored, remove all drawers
and baskets from appliance and place
food on cooling shelves.
Pay careful attention not to exceed the
load limit stated on the side of the
upper section
Important
In the event of accidental defrosting,
for example due to a power failure, if
the power has been off for longer that
the value shown in the technical
characteristics chart under "rising
time", the defrosted food must be
consumed quickly or cooked
immediately and then refrozen (after
cooling).

Excessive temperature alarm

An increase in the temperature in the
freezer compartment (for example due
to an power failure) is indicated by:
- flashing temperature;
- flashing of the icon
- sounding of buzzer.
When normal conditions are restored:
- the acoustic signal shuts off;
- the temperature value continues to
flash;
When you press key "E" to de-activate
the alarm, the highest temperature
reached in the compartment appears
on indicator for some seconds. Then it
returns on the normal operation
showing the temperature of the
selected compartment.
During the alarm phase, the buzzer
can be switched off by pressing key E.
(where applicable).
;