Specifications; Features Of The Remote Controller; To Set The Stopping Time; Set The Starting & Stopping Time - Electrolux R51K/BGE Owner's Manual

Remote Controller Specifications
Model
R51K/BGE,R51K/BGCE
Rated Voltage
3.0V
Lowest Voltage of CPU
2.0V
Emitting Signal
8m (when using 3.0 voltage, it Gets 11m)
Reaching Distance
Environment
-5 C 60 C
~ ~
Temperature Range
Performance Features
1. Operating Mode: COOL HEAT(For Heat pump models only))
DRY FAN and AUTO .
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range : 17 C~30 C.
4. LCD (Liquid Crystal Display) of all functions.
5. Night Light Function
6. Compatible with the former R11.

Features of the Remote Controller

AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP
1
7
MODE ON/OFF FAN
8
2
9
SWING ECONOMY TIMER
3
10
CANCEL
4
RESET LOCK
11
5
R
6
12
DIGITAL DISPLAY
Fig. 1
1

2. To set the STOPPING time.

2.1 Please press the CANCEL button to cancel any former settings.
2.2 Push the TIMER button and the remote controller will show the
last set time for the START operation and the signal "h"
will be shown on the display panel. You are now ready to re-
adjust the TIMER OFF to stop the operation.
2.3 Push the TEMP button to cancel the TIMER ON setting. The
digital area will show "00".
2.4 Push the TIMER button and the remote controller will show the last
set time for the STOP operation and the signal "h" will be shown
on the display panel. You are now ready to reset the time of the
STOP operation.
2.5 Push the TEMP button ( or ) to set the time you want to
stop the operation.
2.6 After setting the TIMER there will be a one-half second delay before
the remote controller transmits the signals to the Air Conditioner.
Then after approximately another 2 seconds, the set temperature
will re-appear on the digital display.
3. Set the STARTING & STOPPING time
3.1 Please press the CANCEL button to cancel any former settings.
3.2 Push the TIMER button and the remote controller will show the
last set time for START operation and the signal "h" will
be shown on the display panel. You are now ready to readjust
the TIMER ON to start the operation.
3.3 Push the TEMP button ( or ) to set the time you want to
start the operation.
3.4 Push the TIMER button and the remote controller will show
the last set time for STOP operation and the signal "h" will be
shown on the display panel. You are now ready to reset the
time of the STOP operation.
3.5 Push the TEMP button ( or ) to set the time you want to
stop the operation.
3.6 After setting the TIMER there will be a one-half second delay
before the remote controller transmits the signal to the Air
Conditioner. Then, after approximately another 2 seconds ,the
set temperature will re-appear on the digital display.
NOTE
! !
1. Please reset the TIMER after cancelling the former time
settings.
2. The setting time is relative time. That is the time set is based on
the delay of the current time.
6