Roland EGX-350 User Manual page 67

If cutter insertion is difficult
If the cutter catches on the solid collet and is difficult to
insert, loosening the cutter holder makes insertion easier.
Note that inserting it with undue force may result in
damage to the workpiece. After inserting the cutter,
tighten the cutter holder again.
˜
Cutter holder
Hexagonal
screwdriver
™
Press .
š
›
œ
This completes the installation of the cutter. Go on to page 75, "Setting the XY Origin Point (Home Position)."
4-5 Cutter Installation Method 2 (No Nose Unit)
Loosen the cutter holder.
Mounting screw
Use and
Press to confirm.
The Z-axis origin is set.
Press .
The main display appears. The coordinate values for Z is set to 0.
When using a diameter-4.36 mm solid collet
Be careful to orient the cutter correctly.
Cutter
Solid collet
Tab
Secure the cutter in place.
Tighten the mounting screw for the cutter
holder.
to select [Z0].
Chapter 4 Engraving
Tab
65