Table of Contents
Advertisement
Caulk Upper Half of Canopy Extension
EAVE INSTALLATION
INFORMATION
IMPORTANT: For under eave installation only,
the sensor head must be rotated as shown in the
next two steps for proper operation and to avoid
the risk of electrical shock.
1. Rotate the sensor head towards the clamp
screw joint (see Figure 8).
2. Then rotate the sensor head clockwise 180° so
the controls face down (see Figure 9).
Note: If the sensor pops out of the ball joint, loosen
the clamp screw and push the sensor back into the
ball joint. Tighten the clamp screw when done.
Clamp Screw
Controls
201111-01
Canopy
Extension
Figure 7
Controls
Figure 8
Figure 9
BULB INSTALLATION AND
REPLACEMENT
CAUTION: When replacing bulb, turn
power off and let the fixture cool.
Important: Use a clean glove or cloth when
handling the new bulb. Use isopropyl (rubbing)
alcohol to clean the bulb if it is touched with
your bare hands.
NOTE: Bulb is included, but needs to be in-
stalled. The bulb is located behind the glass
cover of the lamp head.
1. Open lamp head with a phillips head screw-
driver. To remove the old bulb, push the bulb
towards the right until the left side of the bulb
is clear of the left socket.
2. To install the bulb, place one end of the bulb on
the contact in the right socket. While pushing
the bulb against the right contact, lower the
other end of the bulb onto the contact in the
left socket (see Figure 10).
3. Spin the bulb to verify it is seated properly.
4. Close the lamp head and tighten locking screw
securely.
Bulb
Left
Socket
Contact
5
Lamp Head
1
2
Figure 10
Right
Socket
Glass
Cover
Advertisement
Table of Contents
