Daily Use - Electrolux EDP2074PDW User Manual

Hide thumbs Also See for EDP2074PDW:
Table of Contents

Advertisement

same time for approximately 2 sec-
onds.

7. DAILY USE

Before you use the appliance for the
first time
1. Clean the appliance drum with a moist
cloth.
2. Start a short programme (e.g. 30 mi-
nutes) with moist laundry.
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
3. Press the Start/Pause touchpad, the
programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting the programme with
delay start
1. Set the correct programme and op-
tions for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
• You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad, the
countdown starts. The display shows
the countdown of the delay start.
• When the countdown is completed,
the programme starts.
7.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
7.4 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator
• The indicator
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is al-
most completed or completed.
When the crease guard phase is comple-
ted:
• The indicator
• The indicator
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty
the water container when a pro-
gramme is completed.
7.5 Auto STAND-BY function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the pro-
OFF
gramme.
ENGLISH
flashes.
comes on.
is on but does not flash.
goes off.
OFF
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents