Table of Contents
Advertisement
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 955 101 117
Installation
Unpacking
Check that the cooker hood has no damages. Trans-
portation damages should immediately be reported
to the one responsible for the transport Damages,
faults and eventually missing details should immedi-
ately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall or under a
wall cupboard.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 4).
Electrical connection
The hood has a power cord with moulded plug with
earth connection to be connected to a wall outlet of
230 V.
The power cord length is 1,2 m.
Mounting of hood on wall
Fix the drilling template to the wall (Fig. 5).
Make 3 Ø 8 mm holes in the wall. 2 at points I, 1
as desired at points L.
Insert the three Ø 8 mm expansion plugs into the
wall.
Insert 2 5x45 screws at points I but do not tighten
them completely.
Open the grid.
Fit the hood into holes I, tighten the 2 screws.
From inside the hood, insert the third 5x45 screw
into hole L (Fig. 6).
Flex tube kit
When the hood is to be connected to an evacuation
channel use the flex tube kit containing one evacu-
ation flex tube, one roof connecting duct and two
tube clamps.
Order by the retailer.
PNC 391 414 201
65 cm
Fig. 4
I
Fig. 5
Fig. 6
21
Min
Min
75 cm
I
L
I
L
I
L
Hide quick links:
Advertisement
Table of Contents
