Gembird BTHS-002 User Manual page 7

Switching the Bluetooth
headset off
Volume mute
Redial
Answer a call
End a call
Reject a call
Re-connect to Bluetooth
device
Voice control
Follow the instructions in the table above and prepare the Bluetooth headset for pairing
(when the headset is ready it will emit a series of flashing green and red lights). Then turn
Approximately 5 seconds
Click and hold down the
volume adjustment button
('+'&'-') for 3-4 seconds
Click and hold down the
volume adjustment button
('-') for 3 seconds
Click the button once as
the call is coming through
Click the button once
during the call
Click and hold down the
button for 3 seconds
Click the button once and
then click the button again
after 3 seconds
Click the button once while
the Bluetooth headset is in
standby mode
Bluetooth headset
Will emit a red indicator light
which will stop once the
headset is off
The Bluetooth headset will
mute the call
Redials the last call made from
the mobile phone
Answers the incoming call
Ends the current call
Reject s the incoming call
Will reconnect paired Bluetooth
devices if they have been
disconnected
Voice can be used for dialing,
redialing and answering calls
Once the headset is switched off, the
mobile phone will use its own speaker for
the sounds
The mobile phone has to support the
Bluetooth redial function
Green indicator light will flash twice every
one second until the Bluetooth headset is
reconnected to the Bluetooth devices
The mobile phone has to support this
function