Vacuum Seal Installation; Hose Assembly; Attaching Hose Weights - Pentair Inground Suction Pool Cleaner Installation And User Manual

Vacuum Seal Installation

1. Pull the Vacuum Seal over the Cleaner's
Foot Pad to fi t properly into the Foot Pad's
groove as shown in the illustration.
2. Be sure the curved tips face upwards.
3. Check with your hand that the Vacuum
Seal rotates freely once it is in the groove.

Hose Assembly

1. Connect hose sections to reach from
vacuum/suction source to the farthest point
of the pool, plus one section.
2. Once the hose is assembled, attach the
female hose end onto the swivel of your
Kreepy Krauly

Attaching Hose Weights

The number of hose weights required is determined by the maximum depth of your
pool - the deeper your pool, the more weight is needed. Use the table below to find
the number of hose weights needed for your pool.
1. Attach hose weights to the hose to keep
the cleaner at a 45° angle in the pool for
maximum coverage.
2. If needed, adjust the 1
to the cleaner) towards the 2
(The water density in each pool can vary
due to mineral and salt content).
3. Adjust the hose weights until the cleaner
sits evenly on the bottom of the pool at a
45° angle.
® ™
Kruiser .
st
hose weight (closest
nd
hose weight.
Pool Depth
More than 6 feet, but 1 weight: one 12 to 20 inches
less than 9 feet from the swivel head
2 weights: one 12 to 20
More than 9 feet but
inches, one 6 feet from the
less than 12 feet
swivel head.
3 weights:* one 12 to 20
More than 12 feet inches, one 6 feet and one
10 feet from the swivel head.
*Contact your Pentair Water Pool and Spa
need to purchase additional hose weights.
Hose Weights Note:
illustrated is not representative
of actual size. You will need to
use more sections than shown.
No weights on
the hose cuffs
® ™
Kreepy Krauly Kruiser Installation and User's Guide
3
Weight Placement
® dealer if you
The hose length