Table of Contents
Advertisement
4
Section 3
Installation
Pool With One Skimmer Connection
Use the adjustable regulator valve to balance the water fl ow between the skimmer
and the cleaner - this valve changes the amount of water fl ow to power cleaner.
1. Turn the pool pump off.
2. Close main (bottom) drain and all suction lines, except the line from the skimmer.
3. Remove skimmer basket.
4. Screw threaded compression adapter into the vacuum connection in the bottom
of the skimmer.
Note: Use two wraps of plumber's sealing tape around threads to ensure easy
removal.
(If the opening in the bottom of the skimmer is not threaded, use a 2" hose cone.
It is not included but can be purchased separately).
5. Press the adjustable regulator valve into the threaded compression adapter.
6. Place the Kreepy Krauly
7. Continue to feed hose vertically down into the pool until completely fi lled with
water and purged of air.
8. Slide hose protector sleeve on the hose section connected to the regulator valve
in the skimmer to prevent rubbing against skimmer wall.
9. Insert hose end through the skimmer opening and connect to the adjustable
regulator valve.
10. Open main drain and suction lines and turn the pump on to start the cleaner.
®
™
Kreepy Krauly
Kruiser
Installation and User's Guide
®
Kruiser
Skimmer
™
into the pool and allow it to sink to the fl oor.
Regulator
Valve
Threaded
Compression
Adapter or
Valve Cone
To Pump
No
Regulator Cap
Advertisement
Table of Contents
