Installing The Cleaner; Standard Installation - Pentair Lil Rebel Installation And User Manual

Standard Installation

The 'Lil Rebel™ Aboveground Suction-Side Pool Cleaner is
designed to work in a wide variety of swimming pools. The standard
in-skimmer installation is covered in this section.
1. Turn the pool pump off.
2. Close the main drain and all suction lines, except the line from
the skimmer to which the cleaner will be connected.
3. Remove skimmer basket.
4. Install the reducer cone into the vacuum connection in the
bottom of the skimmer. See Figure 7.
5. Press the regulator valve into the compression adapter. The
valve's adjustment knob should be pointing up. See Figure 6.
6. Place cleaner into the pool. Turn it side to side and front to back
to release any trapped air, allowing the cleaner to sink to the
floor of the pool. Continue to feed the hose vertically down into
the pool until it is completely filled with water and purged of air.
Note: If air is pulled into the pool plumbing it may
cause your pump to lose prime.
7. Insert the end of the hose through the skimmer
opening and connect the hose directly into the
regulator valve. See Figure 7.

INSTALLING THE CLEANER

Figure 7
Hose through
Skimmer
Opening
Regulator
Valve
Reducer
Cone
'LIL REBEL™ Aboveground Suction-Side Pool Cleaner Installation and User's Guide
Figure 6
Attach Hose This End
Regulator
Valve
Reducer
Cone
Press into
bottom of skimmer
Top of Skimmer
3
32" Female/
Male Hose
Attach
Hose
This End
To Pump