Abit SG-72 User Manual page 49

BIOS Setup
Parallel Port Mode:
Enables you to set the data transfer protocol for your parallel port. There are four options: SPP (Standard
Parallel Port), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port) and ECP+EPP.
SPP allows data output only. Extended Capabilities Port (ECP) and Enhanced Parallel Port (EPP) are
bi-directional modes, allowing both data input and output. ECP and EPP modes are only supported with
EPP- and ECP-aware peripherals.
ECP Mode Use DMA:
When the onboard parallel port is set to ECP mode, the parallel port can use DMA 3 or DMA 1.
Back to Integrated Peripherals Setup Menu:
Onboard PCI Device:
Click <Enter> key to enter its submenu:
Onboard LAN Device:
Enables and disables the onboard LAN.
LAN Boot ROM:
Use this item to enable and disable the booting from the onboard LAN or a network add-in card with a
remote boot ROM installed.
Back to Integrated Peripherals Setup Menu:
Init Display First:
Use this item to specify whether your graphics adapter is installed in one of the PCI slots or is integrated
on the motherboard.
3-11
User's Manual