Sirius Satellite Radio SIR-CL1 User Manual page 22

Sedan/Coupe: Route the cable along the rear window underneath the
rubber molding. Use a plastic knife or other blunt object to lift the
window rubber molding and tuck the antenna cable underneath the
window molding. Route the antenna cable around and down the
window to the lowest point, and into the vehicle trunk area using any
existing vehicle cable/wire channel or wiring conduit, if possible. Then,
continue to route the antenna cable through the interior trim of the
vehicle to where the SIRIUS receiver is located.
SUV/Mini Van: Route the antenna cable under the rubber molding of the
rear tailgate/door, and continue routing the antenna cable through the
interior trim of the vehicle to where the SIRIUS receiver is located.
Pickup Truck: Route the antenna cable through the rubber molding of the
brake light on the rear of the cab roof, and continue routing the antenna
cable through the interior trim of the vehicle to where the SIRIUS
receiver is located. If the molding around the cab roof brake light is
made of rigid plastic, drilling a small hole may be necessary to route
the antenna cable into the cab. Seal the hole with silicone caulk or
similar sealant when the installation is complete.
Convertible: Route the antenna cable directly into trunk of the vehicle
where the trunk edge meets the rear window, and continue routing the
antenna cable through the interior trim of the vehicle to where the
SIRIUS receiver is located.
4. Once the antenna cable is routed through the vehicle, and you are satisfied
with the cable routing, remove the protective strips from the adhesive on
the underside of the rubber antenna cable cover/tail, and press the rubber
antenna cable cover/tail firmly into place on the vehicle.
RUBBER ANTENNA
CABLE COVERITAIL
VEHICLE
MOUNTING SURFACE
5. Double check that the location of the antenna and rubber antenna cable