Table of Contents
Advertisement
Something not working?
If the tumble dryer is not working correctly please
carry out the following checks before calling an engi-
neer.
Symptom
The tumble dryer will not start
The results are unsatisfactory
The drying process takes unusually
long
The door cannot be closed
The drum illumination does not
work
The dryer terminates the drying
process automatically: END
(ENDE) is displayed shortly after
program start
The drying process takes unusually
long. 4.5 hours after the beginning
of the drying process:
- END (ENDE) display is illuminated
- acoustic signal sounds
- discontinuation of the drying
process
-
program run display is flashing
If you do not find the required information in this man-
ual to remedy a disturbance, please call the customer
service.
Possible cause
The appliance is not plugged in
The fuse has blown
The START/PAUSE (START/
PAUSE) button has not been
pressed
No program has been selected
The door is not properly closed
The water reservoir is full
The wrong program has been
selected
Fluff filter blocked
The tumble dryer has been over-
loaded
Laundry not sufficiently spun prior
to tumble drying
The vent is covered
A residue may have formed on the
drum interior, blocking the sensors
The vent hose may be obstructed
Fluff filter is clogged
Fluff filter has not been inserted cor-
rectly and/or the filter lid not closed
The program selector is in the OFF
(AUS) position
The bulb needs replacing
Too dry or too little laundry filled-in
for the selected program
SPECIAL CARE (SCHON) button
pressed and too much laundry
filled-in
Too much laundry filled-in
Laundry too damp
Solution
Plug in the appliance
Check the fuse
Press the START/PAUSE (START/
PAUSE) button
Select the required program
Close the door
Empty the water reservoir
Select a different program
Clean the fluff filter
Observe the maximum loads stated
for each program
Ensure the wash load is well spun
before tumble drying
Ensure the vent is clear
Clean the inside of the drum with
white vinegar
Check the vent is not blocked or
squashed
Clean the fluff filter
Replace the fluff filter and ensure
the filter lid is closed
Turn the program selector dial to
LIGHT (BELEUCHTUNG)
Replace bulb
Select time program or higher dry-
ing stage (e.g. EXTRA DRY
(EXTRATROCKEN) instead of
VERY DRY (STARKTROCKEN))
Check the program selection:
SPECIAL CARE (SCHON) button
appropriate only for laundry
amounts up to 2.5kg
Reduce the amount of laundry
filled-in
Pre-dry the laundry more thor-
oughly
19
Advertisement
Table of Contents
