System Connections; Aerial Connection; Ac Power Connection; Demonstration Mode - Sharp DK-KP82PH Operation Manual

System connections

Make sure to unplug the AC power lead before making any connections.
FM aerial
AM loop
aerial
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)

Aerial connection

■
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket
and position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Installing the AM loop aerial:
<Assembling>
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
External FM aerial for better
reception (not supplied)
<Attaching to the wall>
Wall
Screws (not supplied)

AC power connection

■
After checking all the connections have been made correctly,
plug the AC power lead of this unit into the wall socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.

Demonstration mode

■
The first time the unit is plugged in, the unit will enter
●
the demonstration mode.
To cancel the demonstration mode, press the DEMO
●
button (remote control) during power stand-by mode.
The unit will enter the low power consumption mode.
To return to the demonstration mode, press the DEMO
●
button again.
If iPod or iPhone is docked, the unit will begin charging.
●
"Charge Mode" will be displayed. Demonstration
mode is invalid during charge mode.