Display Assembly - HP Pavilion dm4 Maintenance And Service Manual

4. Remove the power connector (5) from the clip built into the base enclosure.
Reverse this procedure to install the power connector cable and bracket.

Display assembly

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Disconnect the wireless antenna cables from the WLAN module (see
on page
6. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
e. Power connector cable (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
66 Chapter 4 Removal and replacement procedures
Battery on page
38).
Optical drive on page
Hard drive on page
Keyboard on page
Top cover on page
37).
44)
46)
55)
57)
Power connector cable on page
WLAN module
65)